hallo,
Falls jemand Interesse hat im Ami forum startet demnächst eine sammelbestellung.
Ich könnte für euch bestellen der Verkäufer hat eh noch Teile die er zu mir schicken muss und ich könnte sie hier dann verteile.
Bremshalter hinten für Brembo Beringer Zange
-
-
Hallo Luis,
ich hätte evtl. Interesse. Müsste sonst an meiner Bastelhawk wegen der NC35-Felge die hintere Bremszange etwas abschleifen...Eine andere Lösung käme mir Recht. Welche Brembozange meinst du bzw. passt an diesen Halter? Und was kostet der Spass in etwa?
Gruß
Tino -
Hallo Tino,
ich antworte mal für Luis:
Price - $200 clear anodized, $215 Type
III Black anodized - plus shipping. IF I sort a forward bolt solution it
will only be a few dollars more - if not - see below. These will ship
with the required spacer regardless and that is included in these
prices.
Plus Bremssattel und Porto.Gruß
Himmi -
Danke Himmi,
ich nehme an, gemeint ist die Beringerzange, die Jan (Moebiusband) mit diesem Bremshalter verbaut hat:
Leichte Bremse fuer hintenNur es klang, als deutete Luis in seiner Threadüberschrift eine Brembozange neben der Beringer an. Welche Brembo wäre dann passend (und wie Moebiusband in obigem Thread schrieb mit 90 EURO günstiger als die Behringer ) ?
Gruß
Tino -
Hi Tino,
ich bestelle eine Trägerplatte für mich selber, habe aber zum Bremssattel momentan auch nur die Infos die der ursprüngliche Hersteller (masanski) im amerrik. Forum gepostet hat. Mehr Infos hat wohl Luis, der uns dann damit beglücken kann.
For the top mount, the brembo 20.5161.71 (black) or 20.5161.90 (gold) that looks like this:
http://www.powersportsfx.com/sa/p/Br...IPER_18129.htmFor the underslung, the brembo 20.5161.81 (black) or 20.5161.43 (gold) that looks like this:
http://www.powersportsfx.com/sa/p/Br...IPER_18127.htmThese calipers are available in black, silver or gold. The 20.5161.90
will actually work on either, because the bleed nipple and banjo bolt
have the same thread and can be swapped from end to end.These are the same caliper body, but you will notice that the banjo hole
is in a different spot on each. The above combinations of moutn and
caliper will keep brake line length to a minimum.With many wheels, the Brembo caliper needs 2.5mm shaving off one side
for clearance to the wheel. This is an easy operation with a milling
maching and die grinder.Gruß
Himmi -
letzter tag
-
teile sind fertig aber noch in USA Lieferung verzögert sich wegen andere Teile die in die Box müssen gehe von Anfang Januar aus.
Sorry
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!